Follow the standard Feathers UI installation instructions.
No additional dependencies are required to target the HashLink virtual machine.
To build for the
hl target, run the following command.
openfl build hl
-debug flag to create a build to include extra debugging information, including full stack traces when there's an exception or crash.
openfl build hl -debug
The build's output will be written to the bin/hl/bin folder.
Your project.xml file may optionally specify an output folder different from bin.
In the example above, the output would be generated in Export/hl/bin instead.
Run / Debug
OpenFL provides the
test command to launch your project using the HashLink virtual machine.
openfl test hl
In the future, common error messages and their solutions will appear in this section.
Did you get some other error message that you don't understand?
Configuring OpenFL builds for various targets can be a little tricky! Head over to either the Feathers UI community forum or the Feathers UI Discord. Explain which command you tried to run, be sure to mention that you are targeting hashlink, and post the error message (and any additional relevant output). Ideally, we can help you figure out a solution, and then we'll also add it to this troubleshooting section, so that everyone can benefit.